Support section
A state-of-the-art leak detection system

The AKWA valve will safely shut off the water supply, regardless if you’ve been away from home for a short or a long period of time. It is hardwired directly to the control unit for an immediate response rate.

The water alarm controller panel centralizes the functions and automatically sends you the leak’s exact location.

A sensor can easily and discreetly be placed under a sink, near a toilet or water heater. It even detects the smallest water leak with an unparalleled level of precision and stays active 24 hours a day, 7 days a week, 365 days a year.

After a 4- to 12-hour period without any movement (depending on the installation settings), a signal is sent to the alarm panel. AKWA then goes into prevention mode and shuts off the valve automatically. AKWA is the first 100% preventive solution on the market!

The technology of this sensing ruler is formed by a thin printed circuit board 20″ long by 1″ wide. The two surfaces of the ruler can capture water along its entire length. They are often installed near dishwashers, water heaters and refrigerators connected to the water supply. As soon as the sensing ruler comes in contact with water, a signal is immediately sent to the dual leak detection probe which in turn sends a signal to the water alarm controller to close the main valve. Once dry, the detection ruler immediately resets itself.
TESTED AND PROVEN COMPONENTS
Each component that makes up the leak detection system complies with the industry’s highest safety standards.
